About

Mechanical Engineering with interest in Design, Analysis and Product Development. 

The ability to perform Modelling, assembly and drafting using CATIA, SOLIDWORKS, Creo Parametric.

Perform CFD using Open Form and ANSA and analyze the model using Ansys workbench.

Other areas of specialization include Numerical Analysis using MATLAB.

Contact Info

Email id - [email protected]

Ph no - 9003275172

LinkedIn ID - https://www.linkedin.com/in/aravinda-subramanian-730722102/

 


Projects by Aravind Subramanian

OBJECTIVE          The aim of the project is to perform a parametric study on the gate value by varying the opening from 10% to 90%. TASK Obtain the mass flow rates at the outlet for each design point. Calculate the flow coefficient a Read more

OBJECTIVE        The objective of the project is to perform a combustion simulation of air and fuel mixture. The effect of the addition of water content into the fuel on the formation of Nox and soot. Assumptions The parameters are axis symmetrica Read more

OBJECTIVE       To perform an analysis on the cyclone separator model using four different boundary conditions & also vary the number of particles through the inlet. Cyclone Separator  It is a method of removing particulates from an a Read more

OBJECTIVE        To Perform a steady-state conjugate heat transfer analysis on a graphics card & Identify the hotspots in the model. TASK        1. Find out the maximum temperature attained by the processor.     Read more

AIM      To analyze the sloshing of gears inside the gearbox due to the meshing of the gears for the fluids with different clearances between the gears.  TASK       The four types of cases are done in this project using two flu Read more

OBJECTIVE          The aim of the project is to perform Rayleigh Taylor instability for two fluids one dense and light fluid at the simulation is done to check the variation at the interface when gravity is present. TASK       Read more

Conjugate heat transfer Conjugate heat transfer (CHT) is used to describe processes which involve variations of temperature within solids and fluids, due to thermal interaction between the solids and fluids. The exchange of thermal energy between the two physical bodie Read more

OBJECTIVE           The aim of the project is to perform a flow analysis over an Ahmed body and perform a grid dependence test by varying the mesh around the Ahmed body. Ahmed Body           Ahmed body is a gener Read more

AIM       The objective of the project is to compare the results by varying the discretization length and convert the 3D model to the 1D model for an intake manifold. Model     The discretization length is set as a parameter in which Read more

SITUATION

          To study the Emission characterization on a CAT3410 engine & combus Read more


Loading...

The End