No overview provided.

Contact Info

Email Id: [email protected]

Phone number : 8369926577

Turbo Charger Simulation Kushal Deokar · 2020-03-26 14:22:12

Objective: To perform the simulation of a turbocharger turbine ,find its contours and output parameters. Theory: A turbocharger, colloquially known as a turbo, is a turbine-driven,forced induction device that increases an IC engine\'s efficiency and power o Read more

Literature review RANS derivation and analysis Kushal Deokar · 2020-03-25 19:45:57

Objective: To Apply reynold\'s decomposition to the NS equations and come up with the expression for reynold\'s stress. Explain your understanding of the terms reynold\'s stress What is turbulent viscosity? How is it different from molecular viscosity? Theory: Read more

Sphere pressing on a plate Kushal Deokar · 2020-03-22 09:30:56

Objective: To perform the structural analysis to simulate a sphere pressing on a plate using structural steel NL as material for plate . Geometry: Provided geometry was imported in spaceclaim .As our geometry was symmetric ,our results would also be symmetrc ,so in o Read more

Rolling operation Kushal Deokar · 2020-03-21 09:05:22

Objective: To simulate the rolling operation on a workpiece made of copper and to evaluate following results: Equivalent stress for the whole setup Equivalent Plastic strain for the workpiece Directional Deformation in the Z axis for the workpiece Prove that the Read more

Super Charger Simulation Kushal Deokar · 2020-03-18 18:37:24

Objective: To Perform a simulation on roots type supercharger ,analyse its performance data and plot the required performance curve for following pressure ratios  Pressure Ratio = [ 1.1 1.5 2.0 2.2] Theory: A supercharger is an air compressor that increase Read more

Verification of Weld Joints Kushal Deokar · 2020-03-17 19:31:25

Objective: To perform a static structural analysis on three different types of welding using three different weld materials Materials: Case 1.  Stainless Steel: In this case, the material of the plates must also be the same. Use Stainless steel for both weldment Read more

Shock tube simulation Kushal Deokar · 2020-03-17 17:05:03

INTRODUCTION: In this project, we are going to set up the geometry of a shock tube and simulate a shock wave inside it to study it movement patterns and how it affects the gasses inside the tube   AIM:To setup a transient shock tube simulation and plot the: Pr Read more

Rayleigh Taylor Instability Kushal Deokar · 2020-03-16 09:24:11

Q1. What are some practical CFD models that have been based on the mathematical analysis of Rayleigh Taylor waves? Rayleigh-Taylor instability (RTI) is the interpenetration of materials that occurs whenever a light fluid pushes on a heavy fluid (Rayleigh 1883, Taylor 1 Read more

Centrifugal pump simulation Kushal Deokar · 2020-03-14 19:25:29

Objective: Perform a centrifugal pump simulation at diffrent massflow rates ,getting the values of pressure, velocity at outlet ,determining the effiency and preparing the performance curve of the pump using the predefined boundary condition. Theory: What is a centri Read more

Bevel Gear Challenge Kushal Deokar · 2020-03-12 05:59:51

Objective: To perform grid dependency test on bevel gear with base mesh size of 6,5 and  4 mm Theory: Grid independent is a very important issue in numerical simulation. Grid-independent means calculational results change so little along with a denser or looser& Read more