Surface Meshing For Cylindrical Module Using ANSA


To Create Surface Mesh to given Cylinder Model.



1. Convert Module Into PID Mode By clicking on the options on ANSA Interface.

2.Check For geometry Errors.

3. Assigning the boundery faces as shown in Screenshot.

4. To create mesh, need to change the Module from TOPE Mode to Mesh Mode.

5. Setup the Perimeter length, and SPOT MESH.

6. Change the element typre into TRIANGLE, and Element Size is 1mm.

7. Mesh has to check for errors and ensure that, no errors- Done.


Surface Mesh For Given Module is Done.


Projects by Patala Gopi Krishna

Objective: Mesh the Interior plastic component of the side door of a passenger vehicle with given quality criteria. After meshing assign thickness and check if the geometry is captured properly. 1. Take the Mid surface manually, mesh the geometry with quality. 2. Tak Read more

Ip Substrate models
Patala Gopi Krishna · 2020-01-07 12:43:01

Objective: Perform geometry clean up and mesh the model for structural analysis with target element size of 5mm for the given Ip Substrate models. Procedure: # Open one IP substrate model and then open quality criteria and go to presentation parameters tab then click Read more

Hood: The hood or bonnet is hinged cover over the engine of motor vehicles that allos access to the engine compartment. hoods are typically made out of steel, but aluminium is rapidly gaining popularity with auto companies. aftermanufacturers may construct hoodsout of Read more

About BMW M6: The BMW M6 is a high-performance version of th 6series coupe/convertible, designed and developed by the motorsport division of the BMW. The BMW M6 was based on the subsequent generations of the 6 series. the BMW M6 concept made its debut at the 2005 Genev Read more

TURBO CHARGER: A turbocharger, cooloquially known as a turbo, is a turine-driven forced induction device that increases an intenal combustion engine\'s efficiency and power outut by focing extra compressed air into the combustion chamber. Turbocharger performance influ Read more Note: 1. Attached American chopper also, due to used in Yacht Garage  2. Instead of CAR used in PDF, American chopper used to place in garage.    Below attached Screen Read more   Note: SW Visualization not supporting in my PC, Only Photoview360 Rendering done. Assembly: SW2019 Parts: SW2018 Read more

Week 6
Patala Gopi Krishna · 2019-08-13 17:17:10 Read more

Gopi Week 4
Patala Gopi Krishna · 2019-08-01 16:32:27 Read more


The End